Front Door with Sidelight and Fanlight: How to Plan the Door Unit Properly
7 minutes read
A front door sidelight brings daylight into the hallway, makes the entrance look more generous and offers room for a letterbox, bell or fingerprint reader. A fanlight above the door fills tall wall openings and adds light from above. To make the door unit weathertight, secure and harmonious, plan dimensions, glass, fittings and structure together from the start.
Options: Sidelight, Fanlight and Combinations
A front door unit consists of the door leaf and fixed elements that are coupled to the door frame or made in a common outer frame:
- One sidelight on the left or right: the most common solution, for example for a letterbox and bell.
- Two sidelights: symmetrical, impressive, ideal for wide openings.
- Fanlight: a fixed element above the door and, where applicable, the sidelights, often used in tall openings in older buildings.
- Combination of sidelight and fanlight: for large entrance fronts.
| Element | Main benefit | Typical infill |
|---|---|---|
| Glazed sidelight | light in the hallway | insulating glass with privacy features |
| Solid sidelight | room for technology, privacy | infill matching the door |
| Part-glazed sidelight | light plus fittings | glass strip with panel |
| Fanlight | light, adapting to tall openings | insulating glass, glazing bars if required |
Front Door Sidelight: Getting the Dimensions Right
The most important figure is the width of the wall opening. From this you deduct the installation joints and divide the remainder between the door leaf and the sidelights. The following applies:
- Fix the door width first: the door should be comfortable to walk through. For step-free access under the German standard DIN 18040-2, a clear passage width of at least 90 cm is needed.
- The sidelight width is whatever remains: very narrow sidelights quickly look out of proportion and leave little room for fittings.
- Allow for fittings: a letterbox needs a minimum width and depth. Check the dimensions of the model you want before fixing sizes.
- Match the height: sidelights are generally the same height as the door so that the outer frame and threshold run through.
How to measure the opening correctly and which standard sizes exist is explained in the article on front door dimensions.
Single-Piece Unit or Coupled Elements?
Manufacturers make door units either in a common outer frame or as individual elements joined with coupling profiles. Large units are often delivered coupled so that they stay transportable. For stability, structurally adequate couplings or mullions are important, especially with tall sidelights and fanlights on windy elevations.
Letterbox, Bell and Technology in the Sidelight
The sidelight is the ideal place for technology, because the door leaf then stays clear:
- Letterbox: through-the-wall letterboxes in the sidelight are filled from outside and emptied from inside. The European standard EN 13724 recommends a posting opening of 230–280 mm or 325–400 mm wide and 30–35 mm high, with the opening mounted at a height of between 0.7 and 1.7 m. More in the article on letterboxes in the front door or sidelight.
- Bell and entry phone: bell push, video door station and nameplate can be integrated into solid panels.
- Fingerprint reader: if the reader is not to sit in the bar handle, the sidelight is an option.
- Lighting and house number: LED strips or illuminated house numbers improve orientation and safety.
Important: every item of technology needs a cable route. Plan conduits and connections before fitting, because adding cable runs through insulated panels afterwards is difficult.
Glass: Light, Privacy and Security
Glazed sidelights and fanlights bring light but also let people look in. Popular solutions are satin-finish glass, patterned glass or glass with sandblasted designs, which let light through and keep eyes out. Details can be found in the article on front door glass.
Plan Security Throughout
A burglar-resistant front door only makes sense if the sidelight beside it does not become the weak point. Under DIN EN 1627, RC2 requires glazing of at least class P4A and RC3 at least P5A. Make sure the resistance class applies to the whole unit of door and sidelight; a glass sidelight near the handle without matching safety glass would undermine the door's protective effect.
Insulation: Look at the Unit as a Whole
Glass usually insulates less well than a foamed door infill. Large glazed sidelights and fanlights therefore tend to increase the heat loss of the unit. Triple glazing and a warm edge reduce this effect. For the legal requirement and for funding in Germany, doors and glazed elements are each assessed by their characteristic values. If you are planning to apply for BEG funding, clarify with your energy efficiency expert which values have to be evidenced for each element. Pay attention to the U_g value of the glazing and the edge seal.
Design Tips for a Harmonious Entrance
- Proportions: sidelights between about a third and half of the door width usually look balanced; with two sidelights, make them symmetrical.
- Coordinate the motifs: glass strips, pilasters and handles should line up in door and sidelight.
- Uniform colour: order outer frame, couplings and panels in the same colour and finish.
- Think about the canopy: wide units need a canopy wide enough that rain does not hit the sidelight fittings; see canopies and entrance areas.
Fanlight: When It Makes Sense
A fanlight is worthwhile above all in three situations:
- Tall openings in older buildings: many late-nineteenth-century and Art Nouveau houses have entrances 2.50 m high and more. A door of that height would be heavy and expensive; a fixed fanlight fills the opening in keeping with the style.
- Dark hallways: light from above falls deep into the space without passers-by seeing in at eye level.
- Proportions of wide units: a continuous fanlight above door and sidelights visually ties the elements together.
Technically, the fanlight is a fixed-glazed element. With large glass areas above circulation spaces, clarify which safety glazing is required. For sun and privacy protection, fanlights can be made like sidelights with satin-finish or patterned glass.
Fitting and Structure
When a narrow door is replaced by a unit with a sidelight, the opening is often widened. That is an intervention in the load-bearing structure: a new lintel has to carry the load over the larger opening. Have such alterations assessed by a structural engineer and, for external walls, clarify whether the façade design is subject to requirements from a development plan or listed-building protection.
For the fitting itself, the same principles apply as for the door: secure fixing, airtight sealing inside, driving-rain-tight sealing outside and clean connections to threshold and floor.
Allow enough staff and lifting equipment for fitting large units, because glazed elements are heavy and fragile.
Checklist for Your Door Unit
- Wall opening measured, split between door and sidelights decided
- Minimum door width for your use met
- Fittings (letterbox, bell, reader) chosen with dimensions
- Cable routes and conduits planned
- Privacy and safety glass matched to the resistance class
- Characteristic values of all elements documented for funding
- Structure clarified if the opening is enlarged
Put together door, sidelights and fanlight directly in the configurator or first look at the front door models.
Frequently asked questions
How wide should a front door sidelight be?
That depends on the wall opening and the door width you want. Subtract the door width from the opening width and what remains is the dimension for one or two sidelights. For a letterbox or bell panel, the sidelight needs enough width for the fitting concerned.
Can a sidelight be added later?
Only if the wall opening is wide enough or is enlarged. That requires work on the masonry with a new lintel and should be checked structurally. It is easier to plan sidelights in when you replace the door.
Does a glazed sidelight worsen insulation?
A glazed sidelight usually has a different U-value from the door. With triple glazing the effect stays limited. Ask for the values of all elements, especially if you are applying for funding.
Which glass suits a front door sidelight?
Insulating glass with privacy features, such as satin-finish or patterned glass, is usual. If the door is to be burglar-resistant, the sidelight must also match the resistance class and so needs the corresponding laminated safety glass.
Sources
Ready for your project?
Configure your products to measure and see the price straight away – or send us your questions.