Skip to content

Business customers only (B2B) · All prices net plus VAT

AluKun
Lift-and-slide doors

Solar control glass for large window areas: choosing g-value, light and selectivity

6 minutes read

Solar control glass limits the heat that enters a room through large windows while still letting in plenty of daylight. Three characteristic values matter: the g-value (energy transmittance), the light transmission and the ratio of the two, the selectivity. Good solar control glasses reach g-values of around 0.3 to 0.4 with high light transmission, but they are a compromise because they also keep out solar warmth in winter.

The three characteristic values explained

g-value (total solar energy transmittance)

The g-value states what proportion of the incident solar energy gets into the room: directly transmitted radiation plus heat that the glass releases inwards. It lies between 0 and 1. The calculation is set out in DIN EN 410. A g-value of 0.35 means that 35 per cent of the solar energy comes in.

Light transmission (LT or τv)

Light transmission describes the proportion of visible light that passes through the glass. It determines how bright the room looks. Important: the g-value alone says nothing about brightness, because it covers the entire solar spectrum including infrared.

Selectivity

Selectivity is the ratio of light transmission to g-value. The higher it is, the more light comes in per unit of heat. A highly selective glass stays bright and still keeps out a lot of heat.

Example values compared

Type of glass g-value Light transmission Selectivity
Double-glazed thermal insulation glass (argon, 1 coating) 0.60–0.72 – –
Triple-glazed thermal insulation glass (argon, 2 coatings) 0.50–0.60 – –
Solar control glass in general 0.27–0.48 product-dependent –
Guardian SunGuard SN 70/35 0.35 70% 2.02
Guardian SunGuard SN 70/41 0.41 70% 1.71

The ranges come from general technical sources, the product values from manufacturer data. The values apply to the stated glass build-up; in insulating glass with further panes they change. What counts is the data in the quotation for your glass.

When solar control glass makes sense

  • Large south and west facades where external solar shading is not possible, for example because of heritage protection, design or lack of space for boxes.
  • Glass roofs and conservatories, where the sun strikes steeply and external protection is hard to implement.
  • Loft conversions with large gable glazing.
  • Offices and practices with screen work, where overheating is particularly disruptive.

Solar control glass is less sensible for north-facing windows or for houses that rely on solar gains in winter. Here you lose more heat in winter than you save on cooling in summer.

The drawbacks, honestly

  • Less solar gain in winter: a low g-value works all year round. If you want to use the low winter sun, you give up free heat.
  • Appearance: depending on the coating, the glass can look slightly tinted, darker or reflective. Combined with ordinary thermal insulation glass in other windows, differences are noticeable.
  • No glare protection: solar control glass reduces heat but not necessarily glare. For screen work, glare protection may still be needed inside.
  • Not adjustable: unlike roller shutters or venetian blinds, the glass cannot be adapted to weather and season.

Solar control glass or external shading?

The German Environment Agency (UBA) names external solar shading and intensive night ventilation as particularly effective measures against overheating. Movable protection such as roller shutters or raffstores has a decisive advantage: it is only active when needed. In winter the sun remains welcome.

In practice the two solutions complement one another:

  • Large, easily accessible windows: thermal insulation glass plus external solar shading.
  • Glass roofs, very large fixed glazing, hard-to-reach areas: solar control glass, possibly combined with internal glare protection.
  • Patio doors under a pergola: the pergola shades in summer; ordinary thermal insulation glass is often enough.

How solar shading fits into the overall proof of summer heat protection is explained in the article avoiding overheating with glass fronts.

Solar control glass in daily life: what to expect

Many clients are surprised by how differently solar control glasses behave. Some practical notes:

  • Colour rendering: neutral glasses hardly distort colours. Older or highly reflective glasses can have a slight blue, green or grey tint.
  • Reflection: from outside, some solar control glasses reflect more than ordinary glass. That offers some privacy by day; in the evening the effect reverses, and with lights on in the room people can see in easily from outside.
  • Feel of warmth at the window: because less radiation comes through, noticeably less heat is felt right behind the pane in summer.
  • Plants: houseplants at the window receive less energy. Light-loving plants are better placed at other windows.
  • Combining with other glasses: if solar control and thermal insulation glass are to sit side by side in one facade, compare samples beforehand.

Worked example: how much does a lower g-value matter?

Suppose 500 W/m² of solar radiation falls on a 6 m² south-facing glazed area on a summer day. With triple-glazed thermal insulation glass (g = 0.55), around 1,650 W of heat enters the room; with solar control glass (g = 0.35), about 1,050 W. The difference of around 600 W corresponds roughly to the output of a small fan heater, and over several hours that makes a clearly noticeable difference to room temperature. The example is deliberately simplified; angle of incidence, shading and frame proportion change the actual values.

Requirements and funding

For new buildings in Germany, section 14 of the Building Modernisation Act requires adequate structural summer heat protection to DIN 4108-2. The g-value of the glazing feeds into the so-called solar gain characteristic there. For renovation, BAFA funds summer heat protection under individual measures through the replacement or installation of external solar shading devices with optimised daylight supply (status: September 2026). Whether solar control glass qualifies for funding in an individual case is something to clarify with your energy efficiency expert. These rules are German; readers in the UK or elsewhere should check their own overheating requirements (in England, Approved Document O) and local schemes.

Remember that solar control glass should not worsen the Uw value: modern solar control coatings are combined with a thermal insulation function. More on the basics is in the article on the g-value and light transmission.

Combining solar control glass with other functions

Solar control coatings can be combined with other glass functions in the same insulating glass unit. Common combinations are:

  • Laminated safety glass for fall-protection glazing or burglar protection
  • Acoustic build-ups with panes of different thicknesses and acoustic interlayer
  • Toughened safety glass for large panes under increased loads
  • Self-cleaning coatings on the outside for hard-to-reach glass areas

Each additional function changes weight, characteristic values and price. Have the data confirmed for the complete build-up. With large lift-and-slide sashes in particular, a heavier glass build-up can mean that a higher hardware class becomes necessary. So clarify all desired glass functions before the sash size is finally fixed.

Checklist for choosing

  • Check orientation and size of the glass area
  • Clarify whether external solar shading is possible
  • Define target values for g-value and light transmission
  • Compare selectivity; higher is better
  • View glass samples on site, especially next to existing windows
  • Keep the Uw value in view for funding and the GModG

Configure your lift-and-slide door or window with suitable glazing in the configurator. If you need a specific solar control glass, we are happy to prepare an individual quotation.

Frequently asked questions

What is solar control glass?

Solar control glass is insulating glass with a special coating that reflects a large part of the solar energy while letting through as much visible light as possible. It lowers the g-value and with it the heat gain through the window.

What g-value does solar control glass have?

Special solar control glasses reach g-values of roughly 0.27 to 0.48. By comparison, triple-glazed thermal insulation glass is typically 0.5 to 0.6 and double-glazed thermal insulation glass 0.6 to 0.72.

Is solar control glass darker?

Good solar control glasses let a lot of light through but are usually slightly darker than ordinary thermal insulation glass and, depending on the product, can look slightly tinted or reflective. A sample on site helps with the decision.

Does solar control glass replace external blinds?

Not entirely. Solar control glass works permanently and cannot be adapted to cloudy days or winter. Movable external shading reduces summer heat gain more and lets solar warmth in during winter.

Sources

  1. Gesamtenergiedurchlassgrad – Wikipedia(opens in a new tab)
  2. Guardian Glass – SunGuard SuperNeutral Produktdaten(opens in a new tab)
  3. § 14 GModG – Sommerlicher Wärmeschutz(opens in a new tab)
  4. Umweltbundesamt – Energiesparende Gebäude(opens in a new tab)
  5. BAFA – Einzelmaßnahmen an der Gebäudehülle (sommerlicher Wärmeschutz)(opens in a new tab)

Ready for your project?

Configure your products to measure and see the price straight away – or send us your questions.

Cover image: Sliding Door Security: Securing Large Glass Doors
Lift-and-slide doors

Sliding Door Security: Securing Large Glass Doors

Burglar protection for sliding doors: what RC 2 to DIN EN 1627 means, which hardware and glass help and how to sensibly upgrade existing patio doors.

6 minutes read

Cover image: Preventing Overheating: Summer Heat Protection
Lift-and-slide doors

Preventing Overheating: Summer Heat Protection

Summer heat protection for windows: what the GModG and DIN 4108-2 require, how Fc and g-values work and which measures prevent overheating behind glass.

6 minutes read

Cover image: Tilt-and-Slide or Lift-and-Slide Door? Compared
Lift-and-slide doors

Tilt-and-Slide or Lift-and-Slide Door? Compared

Tilt-and-slide (PSK) or lift-and-slide (HST) door? Mechanism, sizes, threshold, ventilation, airtightness and price compared, with a decision guide.

6 minutes read

We use strictly necessary cookies so the shop, configurator and basket work. With your consent we also use Google Analytics to measure how the site is used, and marketing signals for advertising. You can change your choice at any time in the footer. Read our privacy policy