Meeting-Stile Windows: How the Double-Sash Window Without a Central Mullion Works
7 minutes read
A meeting-stile window (known in Germany as a Stulpfenster) is a double-sash window without a fixed central mullion. The two sashes close directly against each other, and a meeting-stile strip on the passive sash covers the joint. When open, the whole width is clear – ideal for balcony doors, wide windows in older homes and anywhere clear passage width and an unobstructed view count. The price is a fixed operating order and usually a somewhat higher cost.
Construction of a meeting-stile window
A meeting-stile window consists of:
- Outer frame: all round, but without a vertical central mullion.
- Active sash: the sash in daily use, with the window handle; usually built as a tilt-and-turn sash.
- Passive sash: the sash to which the meeting-stile strip is fixed. It has no handle of its own.
- Passive-sash hardware: a gearbox with a lever in the rebate or edge bolts, which locks the passive sash into the frame at top and bottom.
As WERU describes, when the passive sash is opened, the upper and lower locking points are pulled out of the frame by an internal lever or edge bolt. After that, both sashes can be opened fully.
How a meeting-stile window is operated
Opening:
- Open (or tilt) the active sash with the handle.
- Operate the lever in the rebate on the passive sash – the passive sash is unlocked.
- Swing the passive sash open.
Closing:
- Close and lock the passive sash first.
- Then close the active sash.
FeBa points out that the passive sash must always be closed before the active sash, otherwise the window does not lock correctly. In daily life most occupants use only the active sash and open the passive sash only for cleaning, carrying furniture or a large air exchange.
Advantages
- Full opening: without a central mullion the whole window width is clear. On balcony doors that makes passage easier, with a pram or when moving furniture, for example.
- Unobstructed view: when open, no mullion interrupts the outlook.
- Slimmer central section: the central section made up of two sashes and meeting-stile strip is slimmer than a combination of mullion and two sashes in many systems. For AWS 75.SI, for example, Schüco lists slim meeting-stile profiles for reduced sightlines.
- Classic look: many historic windows are built as meeting-stile windows; the construction suits older homes well.
Disadvantages
- Operating order: the sashes must be opened and closed in the right order.
- Only the active sash can be tilted: the passive sash can usually only be turned.
- Price: meeting-stile hardware is more elaborate than a fixed mullion; WERU names higher costs than for mullion windows as a typical disadvantage.
- Wind load: without a fixed mullion, the hardware carries the entire load in the middle. FeBa points out that a mullion can have advantages under very high wind loads.
Meeting stile or mullion? The comparison
| Criterion | Meeting-stile window | Mullion window |
|---|---|---|
| Opening width | full width | divided by mullion |
| Both sashes independently operable | no | yes |
| Both sashes tiltable | usually only the active sash | yes |
| Central section | often slimmer | often wider |
| Structure in the middle | via hardware | via fixed mullion |
| Price | usually higher | usually cheaper |
For perspective on central sections: REHAU quotes a central section of 118 mm in the slim version of Artevo and 156 mm in the standard; Elvial states at least 156 mm for the mullion of the W59 series. Such values show how strongly the central section shapes the look.
Airtightness and burglar resistance
The meeting-stile strip with its seals closes the joint between the sashes. According to FeBa, modern meeting-stile systems reach airtightness values comparable to mullion windows; under extreme driving-rain loads, the mullion can have a slight advantage.
For burglar resistance, the hardware matters. Meeting-stile hardware with mushroom-head locking at top, bottom and in the meeting-stile joint, plus security strike plates, can be made burglar-resistant. For a resistance class such as RC 2, the entire construction – profile, hardware, handle, glass – must be tested in that combination. More on hardware in the article Mushroom-head locking.
Typical areas of use
Balcony and patio doors
Double-sash balcony doors are particularly often built as meeting-stile doors, because the full passage width is noticeable in daily life. Pay attention to the threshold design – more in the article Balcony door or patio door: dimensions, opening, threshold.
Older homes
In Wilhelminian-era and Art Nouveau houses, double-sash windows without a mullion are typical. A meeting-stile window preserves the proportions of the façade. How to renew period windows coherently is described in the article Window profiles for period homes.
Wide windows with a view
Where a wide window is meant to offer an undisturbed view when open – in the living room, for example – a meeting-stile window is an alternative to a large fixed pane with a single sash.
Meeting-stile windows in uPVC and aluminium
Meeting-stile windows exist in practically all profile systems. With uPVC, the passive sash is reinforced like any sash; because there is no mullion, the reinforcement must take the loads from glass weight and wind particularly well. With aluminium, the stiffness of the profile is an advantage, so tall meeting-stile doors are also possible. For AWS 75.SI, Schüco expressly lists slim meeting-stile profiles for reduced face widths. As a rule: the larger and heavier the sashes, the more important it is to ask the window maker for the maximum dimensions for the meeting-stile version.
Meeting stile and burglar resistance in detail
The meeting-stile joint is a place where burglars could attack, because no fixed mullion holds the sash there. High-quality meeting-stile hardware therefore locks not only at the top and bottom in the frame but also between the two sashes. For a tested resistance class, profile, hardware, glass and handle must be tested in exactly this combination. Ask for the test certificate if you order a burglar-resistant meeting-stile window.
Practical tips
- Decide the active sash: which sash is used day to day depends on furniture and walking route. Choose the side deliberately.
- Passive-sash handle: instead of the hidden lever in the rebate, some hardware has external operating levers, which are more convenient but visible.
- Maintenance: check and lubricate the meeting-stile gearbox and edge bolts occasionally so that locking runs smoothly.
- Insect screens: for meeting-stile balcony doors, pendulum or pleated screen doors that need no central mullion are suitable.
Common operating errors
The most common mistake: the passive sash is not fully locked before the active sash is closed. The window seems closed but is only resting at the meeting-stile side – resulting in draughts and no burglar protection. After closing, check that the passive-sash lever is in the locked position. Some hardware prevents the active sash from closing as long as the passive sash is not locked; ask about that when buying.
Checklist
- Passage width or view important? Then a meeting-stile window.
- Often tilting both sashes individually? Then rather a mullion.
- Decide the active-sash side according to furniture.
- Clarify the security requirement and choose suitable hardware.
- Have the wind load checked for very large elements or exposed locations.
- Brief everyone on operation: all occupants should know the right order for opening and closing.
In the AluKun configurator you choose between mullion and meeting-stile versions for double-sash windows and balcony doors and decide which sash is to be the active one.
Frequently asked questions
What is a meeting-stile window?
A double-sash window without a fixed central mullion. The two sashes close directly against each other; a strip fixed to the passive sash, the meeting stile, covers the joint between the sashes.
How do you open a meeting-stile window?
First the active sash is opened with the handle. Then the passive sash can be unlocked with a lever or edge bolt and opened as well. When closing, the passive sash must be closed first.
Can the passive sash be tilted?
On most versions only the active sash can. The passive sash is usually a plain side-hung sash; some hardware offers special solutions, which you should ask the manufacturer about.
Are meeting-stile windows less secure?
Not in principle. Modern meeting-stile hardware with several locking points can be made burglar-resistant. What matters is that hardware, handle and glazing are tested for the desired resistance class.
Sources
- WERU Lexikon – Stulpfenster: Funktion, Vorteile und Unterschiede(opens in a new tab)
- FeBa Wiki – Stulpfenster: Maximale Öffnung ohne Mittelpfosten(opens in a new tab)
- Schüco Systemeigenschaften AWS 75.SI (PDF, schmale Stulpprofile)(opens in a new tab)
- REHAU – Premium-Fenstersystem ARTEVO (Mittelpartie)(opens in a new tab)
- ELVIAL – W59 SI² CE (Mittelpfosten-Ansicht)(opens in a new tab)
Ready for your project?
Configure your products to measure and see the price straight away – or send us your questions.